How to thread a bobbin pfaff hobby

Bobbin casing with the big gap to the left. Drop the bobbin in and slip the thread into the slit. Hold the little latch open as you pop it back in. Threading the Needle Thread.

Complete manual is available: Sewusa wishes you lots of luck with your machine!

Place the thread clockwise into the bobbin winder tension (1) and run it to the bobbin. There the thread is passed through a hole and held tight. Let go of the thread after a few revolutions. Wind the thread clockwise around the bobbin several times.

Turn the master switch (12) on and press the foot pedal. Also for: Hobby 309. Page Checking the bobbin thread.

Place a bobbin on bobbin winder so that pin H enters slot G. Pass the thread from the spooi around bobbin tension stud wind it around the bobbin a few times and push the bobbin to the right for winding. When the bobbin is full push it to the left and remove it. Re engage the mechanism. Place the bobbin in the bobbin holder with the thread running off as shown in the picture. Pull the thread into the front notch ( A ) on the front side of the bobbin holder.

With one hand under the bobbin case, hold the tail of thread and watch as the thread flows out of the bobbin case. A slight bounce should cause the bobbin case to slide down the thread. If the thread slides out of the case as you pick it up, it needs more tension. If it barely moves down the thread or doesn’t move at all, it needs less tension. The take up lever must be showing.

Ensure the bottom bobbin is threaded correctly. Skip navigation Sign in. Enjoy the videos and music you love, upload original content, and share it all with friends, family, and the world on. Pfaff quilt expressions 4.

Next, take the end of the thread and insert it through one of the holes in your bobbin. Then, wrap the thread around the bobbin a few times to secure it. Keep in mind that there are also pre-threaded bobbins available in craft stores if you do not wish to thread your own bobbins. The midi machine uses a metal bobbin which is magnetised to create the tension.

Unthread and re thread your machine and ensure the needle position in the correct top position for threading. Your sewing machine manual is the best guide on how to thread your particular sewing machine. Always thread the machine with the presser foot up.

The bobbin case should drop down just a bit. Use a screwdriver to turn the screw on the case a little to the left to loosen the tension. If the bobbin case drops quickly inches or more, the tension is too loose.

Grab the cover from the top between your thumbs and fingers, one hand at each end. Rotate the cover up and to the rear and it should come off. Lift the thread holder straight up to remove it.